AdM as a Service Challenge Working Groups

The next Additive Manufacturing as a Service Challenge Face-to-Face Working Group Event will be held on Tuesday 19^th March 2024 at the University of Sheffield Advanced Manufacturing Research Centre (AMRC) Knowledge Transfer Centre . The event is kindly hosted and sponsored by Kaizen PLM and Siemens.

Please do not delay registering as the number of spaces is limited to 150 attendees and the spaces will be offered on a first come, first served basis. The registration will close on 6^th March 2024.

The aim of the event is to discuss priorities for 2024, review the annual report conclusions and present the successful Spiral 2 parts.

The agenda for the day is as follows:

09:00   Arrival – Tea & Coffee ​

09:30   Welcome & Housekeeping​

09:35   Agenda, CDLS welcome, and Objectives for the Day​

09:45   Annual review survey ​

09:55   Executive Group Welcome & priorities for 2024​

10:15   Kaizen PLM & Siemens presentations​

11:15   Coffee break​

11:45   Overview of successful Spiral 2 proposals​

12:00   Stalls: Spiral 2 Stalls part 1​

13:00   Lunch + tour *

14:00   Stalls: Spiral 2 Stalls part 2 ​

15:00   Working Group Meetings​

16:00   WG Co-Chair Summaries & Wrap up​

16:30   Close

*Please note there is a limited number of spaces available for the shop floor tour. PPE is required for the tour and safety shoes are mandatory. The AMRC can provide some PPE and safety shoes, however if you have your own pair then please bring them. The shoes should have as a minimum requirement a sole plate with a toe cap and have slip resistant thread.

The event address is: Advanced Manufacturing Park, University of Sheffield, Knowledge Transfer Centre,  Brunel Way, Catcliffe, Rotherham S60 5TZ

Parking is available on site on a first come first serve basis.

If you have any questions about the registration process, please contact Kelly . If you have any questions about the event, then please contact Edit or Stu.